Holybro
Pix32 v6
- Processor
- STM32H743, Cortex-M7, 480 MHz, 2 MB flash, 1 MB RAM
- IMU
- ICM-42688-P, BMI088
- Autopilot power input
- 6 V maximum
GST and delivery included
Browse the shop
Pixhawk-standard autopilots for PX4 and ArduPilot, FPV flight controllers, all-in-one boards and flight controller and ESC stacks. Check the processor, the interfaces your peripherals need and whether the controller needs a separate baseboard.
Holybro
GST and delivery included
Holybro
GST and delivery included
Holybro
GST and delivery included
Holybro
GST and delivery included
Holybro
GST and delivery included
Holybro
GST and delivery included
Holybro
GST and delivery included
Showing 7 of 7 products.
Pixhawk-standard autopilots are built for PX4 and ArduPilot missions: GPS navigation, telemetry, companion computers and CAN peripherals. FPV controllers are smaller and cheaper, built for manual flying first.
Some autopilots are a flight-controller module that plugs into a baseboard sold separately; the product page says so. A baseboard on its own does not fly anything.
List every peripheral (GPS, telemetry, RC receiver, companion computer, power module, CAN devices) and check the controller has a port and the right voltage for each.
A baseboard only carries connectors and power for a flight-controller module; it cannot fly anything by itself. They are listed here so you can order the pair, and the starting price for this page counts flight controllers only.